Twilight Trim Configurator

Spektrum+ Twilight Trim Configurator

Use this calculator to estimate products and counts required for your permanent home lighting installation, using Spektrum+ Twilight Trim. 

You may take the results from the Material Estimator and add your values to the products below to configure your system and get an estimate or place an order.

Steps:

1) Measure your rooflines for each zone.  Typically zones are broken up by floors of the house or major sections, such as garage vs main house.  See the Zone Definition Guide below for an example.

2) Measure distance from the Controller to your zones.  This will dictate the length needed for jumper cables to each zone.  It is recommended that you use channels to protect the wires wherever possible. Chase Channel is reremmended for this application.  

3) Note if there are any breaks in the eaves, etc where you may not have dots.  These are best managed with short jumpers between dot strands.

4) Determine how you would like your lighting to look.  Choose between a straight down look from the middle of your eaves or where your eaves meet your house walls with the basic facer channels, choose an angled look - facing toward or away from your house with 45 degree channels. or a combination of both.

5) Enter information on your zones and mounting options into the Configurator.  Set your jumper percentage and waste percentage, or keep with the recommended 10% for each.

6) Hit AutoRebalance on the Configurator. 

Use this recommendation to order your Spektrum+ Twilight Trim components in the fields below.  Unoppened, unused products can be returned for credit.  We recommend ordering a little extra to facilitate your install in one effort.

Please contact Novelty Lights Sales if you have any questions on your set-up.  1-800 209-6122.  [email protected]